Re: Service entry point lost

Hi Ewout,

This is a known problem with Service Entry Point, and it will be addressed
in the next release of WDSc.

For now, there is a work around.  Go to the right top corner of Service
Entry Point view, click on the drop down arrow there, and then click Clear
all service entry points.  Then Set the service entry point again.

Thanks,

Xuan Chen,  Problem Determination Tools for iSeries
(905) 413-3769 T/L 969-3769
xuanchen@xxxxxxxxxx




                                                                           
             "Ewout N Boter"                                               
             <ewout.boter@abbo                                             
             tt.com>                                                    To 
             Sent by:                  wdsci-l@xxxxxxxxxxxx                
             wdsci-l-bounces@m                                          cc 
             idrange.com                                                   
                                                                   Subject 
                                       [WDSCI-L] Service entry point lost  
             06/28/2005 10:14                                              
             AM                                                            
                                                                           
                                                                           
             Please respond to                                             
                 Websphere                                                 
                Development                                                
             Studio Client for                                             
                  iSeries                                                  
                                                                           
                                                                           




When I set a service entry point on a program, and I hit that program in
an iSeries job, a debug session is started automatically. Really
wonderful. But now, when I make a change to the program, do a recompile,
and then hit the program again, no new debug session is started. Removing
the service entry point and then setting a new point does not do the
trick. I can't get the service entry point back to work. Therefore, I have
to return to the use of STRRSESVR.

Any ideas?

Ewout
--
This is the Websphere Development Studio Client for iSeries  (WDSCI-L)
mailing list
To post a message email: WDSCI-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/wdsci-l
or email: WDSCI-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/wdsci-l.