[WDSCI-L] PRTF width using WDSC / CODE Designer

[jstevens@xxxxxxxxxxxxxx]

I've checked the archives on this one, and there was another thread close 
to this.  However, I am setting my report width to 198, but when the 
source is compiled, it still generates a PRTF with 132 width.  I then have 
to do a CHRPRTF PAGESIZE(66 198 ) command.  There is not a "WIDTH" keyword 
or something like that, so I think that the only way to set the width on a 
PRTF is via the CRTPRTF or the CHGPRTF command. 

Does anyone have suggestions on getting the compile command in CODE to set 
the page width from the settings in the DDS file?  (I know that you can 
change the command defaults - say to 66 x 198, but that would work until I 
go to compile a PRTF that is - say 66 x 132).


Thanks!

Jeff Stevens
Mize, Houser & Co. P.A.
913 451 1882
JStevens@xxxxxxxxxxxxxx