[WDSCI-L] Re: QRPLOBJ Help (reply to Xuan Chen)

[sthompso@xxxxxxxxxxxxxxxxxxxxx]

Thanks!  I'll try to answer your questions.

        1.  The names of the *USRSPC objects are all different.  Here's a 
representative sampling of 8 consecutive ones from approximately the time 
I had the debugger sitting idle (although it's not possible for me to tell 
for sure -- I'm not authorized to look at the objects).  If you need more 
information  about these objects, I can try to get an authorized person to 
look at them.
Q698658335
Q6986584AF
Q6986584B7
Q69865840C
Q69865841A
Q69865AFEF
Q69865AFF9
Q69865B0FF
        As I mentioned, the text description is identical on all: 
QTEMP/RSEUTILS.

        2.  I launched a  CL program in the Debugger.  I do not recall 
specifically what steps I completed before I switched to a different 
platform, but I may have just left it there, launched but with no 
breakpoints.  At no time did I actually step through the program or 
monitor any variables or use any other debugger facilities.  (As a matter 
of fact, the Step buttons were grayed out and I really could not do much 
with it...)  Eventually I terminated the launch, but I think this was 
after I came back from the other platform and was preparing to shut down.
___________________
Suzanne
(508) 949-4139    voice
(508) 949-4384    fax
The contents of this email may be confidential.  If you are not the intended 
recipient of this email, any access to, disclosure, copying, or distribution of 
this information, is prohibited and may be unlawful.  If you receive this email 
in error, please reply to the sender immediately to advise him/her of the 
error, and then delete this email and any attachments.