Re: [WDSCI-L] can I get a command line

[Kushal Munir <kmunir@xxxxxxxxxx>]

You can run commands in multiple ways from WDSC. You can use the iSeries
commands subsystem in the Remote Systems view to run and save commands.
Also, the iSeries Commands Log will let you prompt and run commands and see
the messages. The iSeries Table view lets you do the same.

If a view is not open, go to Window menu and select Show View->Other...,
and look under iSeries.

Kushal Munir
Websphere Development Studio Client for iSeries
IBM Toronto Lab, 8200 Warden Ave., Markham, ON
Phone: (905) 413-3118        Tie-Line: 969-3118
Email: kmunir@xxxxxxxxxx



                                                                           
             <GKelly@sungardfu                                             
             tures.com>                                                    
             Sent by:                                                   To 
             wdsci-l-bounces@m         <wdsci-l@xxxxxxxxxxxx>              
             idrange.com                                                cc 
                                                                           
                                                                   Subject 
             04/05/2005 03:37          [WDSCI-L] can I get a command line  
             PM                                                            
                                                                           
                                                                           
             Please respond to                                             
                 Websphere                                                 
                Development                                                
             Studio Client for                                             
                  iSeries                                                  
                                                                           
                                                                           




Is it possible to get a command line to be able to enter commands while
in WDSC or do I need to go back to the green screen? Thanks.
gkelly



--
This is the Websphere Development Studio Client for iSeries  (WDSCI-L)
mailing list
To post a message email: WDSCI-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/wdsci-l
or email: WDSCI-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/wdsci-l.