Re: [WDSCI-L] unable to run an interactive command

[Don Yantzi <yantzi@xxxxxxxxxx>]

Jerome,

Do you have an internet connection from the PC where you are running the
check PTF tool (Verify Connection?)  The tool checks the www.ibm.com
website to get a list of the latest required PTFs, otherwise it just checks
for PTFs that we knew about when the product shipped.

If this is the case then you can get the latest PTF list for RSE from:

http://www-1.ibm.com/support/docview.wss?rs=0&org=SW&doc=7002212&loc=en-us

Don Yantzi
WebSphere Development Studio Client for iSeries
IBM Toronto Lab
Phone: (905) 413-4476
IBM internal:  IBMCA(yantzi)  -  Internet: yantzi@xxxxxxxxxx



                                                                           
             "Jerome Klotz"                                                
             <jklotz@xxxxxxxxx                                             
             >                                                          To 
             Sent by:                  <wdsci-l@xxxxxxxxxxxx>              
             wdsci-l-bounces@m                                          cc 
             idrange.com                                                   
                                                                   Subject 
                                       [WDSCI-L] unable to run an          
             10/08/2004 12:04          interactive command                 
             PM                                                            
                                                                           
                                                                           
             Please respond to                                             
                 Websphere                                                 
                Development                                                
             Studio Client for                                             
                  iSeries                                                  
                                                                           
                                                                           




Dear all,
I have installed WDSc 5.1.2 and have all necessary PTF installed on the
iSeries (V5R1).
I haven't yet installed all the fix packs, but I will do it in a couple
of days.

I have started the communications deamon and also successfully started
the STRRSESVR.

I am running Windows XP SP2, and to make sure the built-in firewall does
not block anything, I have temporarily disabled it, to make sure the
communication with the iSeries is okay.

However, when I try to run an interactive command, I keep on receiving
the following message:

EVFC2041W

Missing Host PTF. The requested fuction is not available.
(I translate the message because the original message is in french)


The system proposes me to check the PTF. It tells me that all PTF are
installed.

Then, the RSESVR is shut down without any message.


What is wrong with what I do ?


Best regards,
Jerome Klotz
Sylog Consulting SA, Switzerland.


_______________________________________________
This is the Websphere Development Studio Client for iSeries  (WDSCI-L)
mailing list
To post a message email: WDSCI-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/wdsci-l
or email: WDSCI-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/wdsci-l.