[WDSCI-L] Can not get breakpoints set in RSE source to work

[Dave Murvin <davem@xxxxxxxx>]

I have been having a hard time figuring out how/where to set breakpoints to 
debug a program.

I was setting break points in the source module in the RSE perspective, 
then trying to debug the program object interactively going through the 
debug menu.  When I selected Resume in the Debug perspective, I assumed 
that the program would run to the first break point I had set.  Instead, 
the program runs to completion without stopping at any break points.

What I discovered is that the Debug perspective brings up the program to be 
debugged in a separate pgm.listing view.  When I set the break points in 
this listing view, the debugger stops at the break points as expected. None 
of the breakpoints set in the RSE source view were transferred to this 
pgm.listing view.

What is the purpose of setting the break points in the RSE perspective view 
of the source if they are not recognized by the debugger?  Am I missing 
something?  I spent quite a while figuring out how to get any break points 
to work.  It was very frustrating.

I am using WDSCi 5.1.2.1 and V5R3

Thanks.


Dave Murvin
DRM Enterprises, Inc.