[WDSCI-L] Just installed 5.1

["Bartell, Aaron L. (TC)" <ALBartell@xxxxxxxxxxxxxx>]

Hi all,

I just installed 5.1 with seamless ease and migration from 5.0(thanks for
that!).  I have come across my first problem:-)  When I first open WDSc 5.1
I don't have it connecting to my iSeries, but I do have it retain the state
of my environment (all of my RPG source members are open as I left them).
In 5.0 I could immediately start editing the source members without having
to connect, and when I saved it the connection would automatically happen.
With 5.1 if I don't connect to my iSeries manually before I do a save on my
source member it just sits there locked stating that it is connecting to my
iSeries, but after 3 minutes nothing has happened (usually takes 5 - 8
seconds).

I tried clicking the "Cancel current process" red square beside the
scrolling "Working on something" indicator at the bottom of the screen.  It
just sits there and hangs. . . Same is true if I try to do an Outline on a
2000+ line source member (99% is sub procs).


Just like Mike Wills I also cannot seem to get Code Assist to work for
variables or bifs.  I type in % and then Ctl + Enter and nothing happens.  I
looked through the LPex editor settings and didn't see anything in there.

Any suggestions?  

**Note** I don't have all of the "Missing PTF's" installed yet being that I
just installed this last night.  

Aaron Bartell

p.s. WDSc 5.1 does start faster and I thank you for that!