[SYSTEM21] Production details item type

["Kincer, Alan" <akincer@xxxxxxxxx>]

In 3/MDM I am trying to change an item type from 'M' to 'P'

Upon pressing Enter I get a message that says "Route defined for this item -
F14 to accept."

Upon F14'ing I am taken to the next screen where I am to press F8 to update.
However at this point I get the message ... "UMS0121 Schedule Control only
valid for Production Items (Item Type 'M')".

What do I need to do to be able to change this item type? Would there be
negative repercussions doing so? 

Thank you...

Alan
  


=== [ KI (USA) Corporation - http://www.kiusa.com ]
====================================== 
Tel. 859.986.1420  --  Fax. 859.986.1485 
This e-mail, including any attachments, contains information from KI (USA)
Corporation that may be confidential or privileged. Mail is intended only
for those to whom it is addressed. If you are not the intended recipient do
not copy, distribute, or take any action in reliance on the contents of this
message. 
If you have received this e-mail in error notify the sender immediately then
delete or destroy all electronic and hard copies of this communication,
including attachments. 
KI (USA) Corporation's anti-virus system checks for known viruses. However
you are advised to run your own virus check before opening any attachments
received. KI (USA) Corporation will not accept any liability once an e-mail
and/or any attachment is received. 
Views expressed in the e-mail are those of the author and not necessarily
those of KI (USA) Corporation. 
============================================================================