Use array to load file fields

Ok, I am sure I have done this in the distant past but for the life of me it is escaping me.

I have a file with lots of similar fields like SeCarr1AD1, SeCarr1AD2 .....
I want to be able to load these using an array like Carr1AcsDscAry(x) = 'Description'

I have tried it with *Next and like below.

I know it's simple but just missing it.


Dcl-Ds Carr1AcsDsc;
Carr1AcsDscAry Like(SeCarr1AD1) Dim(7);
SeCarr1AD1 Overlay(Carr1AcsDscAry : 1);
SeCarr1AD2 Overlay(Carr1AcsDscAry : 51);
SeCarr1AD3 Overlay(Carr1AcsDscAry : 101);
SeCarr1AD4 Overlay(Carr1AcsDscAry : 151);
SeCarr1AD5 Overlay(Carr1AcsDscAry : 201);
SeCarr1AD6 Overlay(Carr1AcsDscAry : 251);
SeCarr1AD7 Overlay(Carr1AcsDscAry : 300);
End-ds;

Ideas?

Thanks!!



Subject to Change Notice:

WalzCraft reserves the right to improve designs, and to change specifications without notice.

Confidentiality Notice:

This message and any attachments may contain confidential and privileged information that is protected by law. The information contained herein is transmitted for the sole use of the intended recipient(s) and should "only" pertain to "WalzCraft" company matters. If you are not the intended recipient or designated agent of the recipient of such information, you are hereby notified that any use, dissemination, copying or retention of this email or the information contained herein is strictly prohibited and may subject you to penalties under federal and/or state law. If you received this email in error, please notify the sender immediately and permanently delete this email. Thank You

WalzCraft PO Box 1748 La Crosse, WI, 54602-1748
www.walzcraft.com<http://www.walzcraft.com> Phone: 1-800-237-1326