|
This is not new to me, but this one is.
I am trying to debug the service program HSSFR4. I have compiled and run it
with DBGVIEW(*SOURCE) and DBGVIEW(*LIST).
When I run the program and it calls the sub procedure, it will show me the
first line of the source of the service program. Clicking "step into"
returns to the calling program.
It will not allow me to set a break point in the service program, setting
the break point on the last line of code in the service program. Not much
help this.
Does anyone know why it behaves this way?
Darryl Freinkel
--
This is the RPG programming on the IBM i (AS/400 and iSeries) (RPG400-L)
mailing list
To post a message email: RPG400-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/rpg400-l
or email: RPG400-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/rpg400-l.
As an Amazon Associate we earn from qualifying purchases.
This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].
Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.
midrange.com
