RE: SQL Cursor return to client issue while using views

Took out the changes to the concatenating to create the parmschvalue contents.

''%DAY%' ' is now '%DAY% '.

Declare SQL now looks like:

DECLARE tableGET CURSOR WITH RETURN TO CLIENT FOR SELECT * FROM TABLEVW1 WHERE UPPER ( CLASSDESC ) LIKE CASE WHEN '%DAY% ' <> ' ' AND 'Y' = 'Y' THEN '%DAY% ' ELSE UPPER ( CLASSDESC ) END AND UPPER ( CLASSCODE ) LIKE CASE WHEN '%DAY% ' <> ' ' AND 'Y' = 'N' THEN '%DAY% ' ELSE UPPER ( CLASSCODE ) END;

And it successfully ran as a standalone SQL statement. But fails within the program.

steve
-----Original Message-----
From: rpg400-l-bounces@xxxxxxxxxxxx [mailto:rpg400-l-bounces@xxxxxxxxxxxx] On Behalf Of Needles,Stephen J
Sent: Friday, May 11, 2012 11:23 AM
To: RPG programming on the IBM i / System i
Subject: RE: SQL Cursor return to client issue while using views

DECLARE TABLEGET CURSOR WITH RETURN TO CLIENT FOR SELECT * FROM TABLEVW1 WHERE UPPER ( CLASSDESC ) LIKE CASE WHEN ''%DAY%' ' <> ' ' AND 'Y' = 'Y' THEN ''%DAY%' ' ELSE UPPER ( CLASSDESC ) END AND UPPER ( CLASSCODE ) LIKE CASE WHEN ''%DAY%' ' <> ' ' AND 'Y' = 'N' THEN ''%DAY%' ' ELSE UPPER ( CLASSCODE ) END;

-----Original Message-----
From: rpg400-l-bounces@xxxxxxxxxxxx [mailto:rpg400-l-bounces@xxxxxxxxxxxx] On Behalf Of Luis Rodriguez
Sent: Friday, May 11, 2012 10:39 AM
To: RPG programming on the IBM i / System i
Subject: Re: SQL Cursor return to client issue while using views

Steve,

Could you post your SQL statement as iNav sees it, i.e., with the full
value of your variables (without the ":")?

Regards,

Luis Rodriguez
IBM Certified Systems Expert - eServer i5 iSeries