eval *Off *In13
eval *Off *InKc

and so on
 Good Luck
Bill
(All in favour of saving gas, raise your right foot!)




________________________________
From: Alan Shore <AlanShore@xxxxxxxx>
To: RPG programming on the IBM i / System i <rpg400-l@xxxxxxxxxxxx>
Sent: Wednesday, July 8, 2009 11:00:19 AM
Subject: How do I define *IN13, *in82 etc

Morning all
I'm hoping that I wont need to go into too much detail, so here goes
We have a program that uses a workstation (DSPF)
To cut a LOOOOOOOONNNNNNGGGGGG story short, the program does NOT display
ANY of the screens from this display file
Where ever there is an EXFMT, there is code to "jump" around the EXFMT - I
hasten to add NOT MY DESIGN
We now have a reason to remove this DSPF (workstation) from the program.
Any fields used within the program from the DSPF, I am just defining in the
D specs
However, indicators like *IN13, *IN82 *INKC *INKF etc. etc. are now
receiving the RNF7030 compile error (NOT DEFINED)
Rather than try and change the logic within the program, the question is
How can I define these indicators (that is if I can)?

Any help (as always) will be MUCH appreciated



Alan Shore
Programmer/Analyst, Distribution
E:AShore@xxxxxxxxxxx
P:(631) 200-5019
C:(631) 880-8640
"If you're going through Hell, keep going" - Winston Churchill

This thread ...

Follow-Ups:
Replies:

Follow On AppleNews
Return to Archive home page | Return to MIDRANGE.COM home page

This mailing list archive is Copyright 1997-2019 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].