RE: Stange case not showing output except in DEBUG

I just had a strange but seemingly similar issue here involving *nopass parms... My program would run correctly if I stepped through in debug, but failed to produce the correct results if running to breakpoint (after the code that fails). I changed from *nopass to *omit, which corrected my issue. I have not yet determined why *nopass was causing the problems it did....

Eric DeLong

-----Original Message-----
From: rpg400-l-bounces@xxxxxxxxxxxx
[mailto:rpg400-l-bounces@xxxxxxxxxxxx]On Behalf Of Phil Kestenbaum
Sent: Tuesday, July 01, 2008 10:17 AM
To: RPG programming on the AS400 / iSeries
Subject: Stange case not showing output except in DEBUG


HI I just ran a RPG program that in normal run it does not show some
detail lines, in the output Printer format area, but when running this
in DEBUG, I see that it does touch these statements and does indeed
produce the correct result.



Is there anything that strikes you as to why this would happen?



Thank you,

Phil


This message contains information proprietary to our company. It is intended to be read only by the individual or entity named above or their designee.
Any distribution of this message or the information contained herein without written permission from our company is strictly prohibited. If the reader of this message is not the intended recipient or an agent responsible for delivering it to the intended recipient, you are hereby notified that you have received this document in error and that any review, dissemination, distribution, or copying of this message is strictly prohibited. If you have received this communication in error, please notify us immediately by e-mail, and delete the original message.