× The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.


  1.  Home
  2. RPG400-L
  3. December 2007

SETGT *End/*Start


We are on 5.3 and I can not use the *END or *START
with SETGT as shown below. In SEU the error message
RNF5318 pops up when enter is pressed. I can not find any
docs on the cause of error or that I can even use the *START/*END
with SETGT. However, they both work fine for SETLL.

Am I missing a PTF??

thanks
JoeM
-----------------------------------

C *START SETGT ITEMBL

Factor 1 entry has a data type that is not allowed for this operation; speci...


-----------------------------------
F1 on message line
-----------------------------------
Additional Message Information

Message ID . . . . . . : RNF5318 Severity . . . . . . . : 30
Message type . . . . . : Diagnostic

Message . . . . : Factor 1 entry has a data type that is not allowed for
this operation; specification is ignored.
Cause . . . . . : The Factor 1 entry (positions 12 - 25) must have the
correct data type.
Recovery . . . : Correct the Factor 1 entry (positions 12 - 25). Compile
again.

As an Amazon Associate we earn from qualifying purchases.

This thread ...
Follow-Ups:
Follow On AppleNews
Return to Archive home page | Return to MIDRANGE.COM home page

This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].

Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.