Re: Driver for ISeries - HP Color Laser Jet 2840

It would help if you showed us your device description for this printer.
The IBM Knowledge Base on their support site lists this:
Make sure your printer is in PCL mode, not postscript



HP Color Multifunction and All-in-One Printers Printers Printer
     Data Stream Host-
     Based PDT File
     for PC5250 MFRTYPMDL
     for HPT LPR PJL SNMP IPP
     HP Color LaserJet 2800 all-in-one
     HP Color LaserJet 2820
     HP Color LaserJet 2840 HP PCL6 N hppcl5.pdt
     HPLJ4.PDT *HPCOLORLJ Y Y Y -
     PostScript 3 N n/a n/a N N N N


Jim Franz

To: "RPG programming on the AS400 / iSeries" <rpg400-l@xxxxxxxxxxxx>
Sent: Friday, December 08, 2006 9:19 AM
Subject: Driver for ISeries - HP Color Laser Jet 2840

Hello All,

We have just installed the above printer and have connected it to the
iSeries using an IP address. We find that  the spools from the iSeries are
not accepted properly by the printer. It gives an error 'Unexpected size
in tray 2', and after resetting it prints the whole spool again & then
gives the error again. In doing so each spool is printed 3 to 4 times.

Anyone had this experience before & any idea how this can be solved ???

Thanks & best regards
Ewart
--
This is the RPG programming on the AS400 / iSeries (RPG400-L) mailing list
To post a message email: RPG400-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/rpg400-l
or email: RPG400-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/rpg400-l.