Re: Probem w/ bad data during subfile load

You're probably getting that error becuase you're calling MYPGM and not
passing the correct parameters.

On 6/5/06, steema@xxxxxxxxxxxxx <steema@xxxxxxxxxxxxx> wrote:

HI - I am getting this error cond. during the subfile load. Is there a way
to monitor for it and bypass so that the subfile doesn't hang? thanks,
Steve
Message ID . . . . . . :   CPF9999       Severity . . . . . . . :   40
Message type . . . . . :   Escape
Date sent  . . . . . . :   06/05/06      Time sent  . . . . . . :
08:59:43

Message . . . . :   Function check. MCH3601 unmonitored by MYPGM at
   statement 0000000054, instruction X'0000'.
Cause . . . . . :   An escape exception message was sent to a program
which
   did not monitor for that message. The full name of the program to which
the
   unmonitored message was sent is MYPGM MYPGM MYPGM. At the time the
   message was sent the program was stopped at higher level language
statement
   number(s) 0000000054. If more than one statement number is shown, the
   program was a bound program. Optimization does not allow a single
statement
   number to be determined. If *N is shown as a value, it means the actual
   value was not available.
Recovery  . . . :   See the low level messages previously listed to
locate the
   cause of the function check.  Correct any errors, and then try the
request
--
This is the RPG programming on the AS400 / iSeries (RPG400-L) mailing list
To post a message email: RPG400-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/rpg400-l
or email: RPG400-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/rpg400-l.