RE: newbie prototype question...

If you want to pass a numeric param using command line, you will need to
declare it as 15p 5. 
     D  num1                         15  5
     D  num2                         15  5

-----Original Message-----
From: rpg400-l-bounces+lim.hock-chai=usamobility.com@xxxxxxxxxxxx
[mailto:rpg400-l-bounces+lim.hock-chai=usamobility.com@xxxxxxxxxxxx] On
Behalf Of Jake M
Sent: Tuesday, March 28, 2006 10:47 AM
To: RPG programming on the AS400 / iSeries
Subject: newbie prototype question...

I am trying to execute a simple prototype program but I keep getting an
error(it compiles fine). I am calling the program as follows:

CALL PGM(MYLIB/PROTO) PARM(1 2)

There might be a very simple mistake I am doing..I am also looking for a
very simple example on a subroutine program and a program which uses
/COPY.
Any help in this matter will be greatly appreciated.

     D addnums         PR                  EXTPGM('PROTO')
     D  num1                          1  0
     D  num2                          1  0

     D addnums         PI
     D  num1                          1  0
     D  num2                          1  0


     D  num3           S              1  0

      /free
         num3 = num1 + num2;
         dsply num3;
         dsply 'DONE';
         *inlr = *on;
      /end-free

Error:

D
Pointer or parameter error (C G D F).

Thanks in advance,

Jake.
--
This is the RPG programming on the AS400 / iSeries (RPG400-L) mailing
list To post a message email: RPG400-L@xxxxxxxxxxxx To subscribe,
unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/rpg400-l
or email: RPG400-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives at
http://archive.midrange.com/rpg400-l.