Mixing Subroutines & Sub-Procedures.

I created a simple sub-procedure in an existing program, and tried to
reference an existing subroutine. The compiler didn't recognize the
subroutine reference. I thought it might be a scope issue and so took a
copy of the subroutine code and copied it into the body of the procedure
just before the Procedure End statement.  
The program worked.

I then removed the code for the subroutine from tha main body of code.
No good. The compiler couldn't see the subroutine sitting in the body of
the sub-procedure. Presumably because of scope again.

The problem now is that I have the same code in two places in the
program. 

Is there an easy way out?



Mike Pantzopoulos
EIG-Ansvar Limited
Tel  : 61 (3) 9614 3535
Fax: 61 (3) 9614 2740



*********************************************************************************************************
This email and any files transmitted with it are confidential and intended 
solely for the use of the individual or entity to whom they are addressed. If 
you are not the intended recipient, any use, disclosure or copying of this 
message is unauthorised. If you have received this message in error, please 
reply using the sender's email address. 

This footnote confirms that this email message has been scanned for computer 
viruses. EIG-Ansvar Limited does not accept liability for any loss or damage, 
whether caused by our own negligence or not, that results from a computer virus 
or defect in the transmission of this email or any attached file. 
EIG-Ansvar Limited - Australia (A.B.N. 21 007 216 506)
Email : insure@xxxxxxxxxxxxxxxx

Eig-Ansvar Limited - New Zealand
Email : insure@xxxxxxxxxxxxxxxx

*********************************************************************************************************