Back with DBGVIEW & *SRCSTMT again!

Dear Bob,

               I compiled a program TESTCQS using DBGVIEW (*SOURCE) and
option (*SRCSTMT) and 

               tried to give the command BREAK TESTCQS/ 000700 -- where
000700 is actually a line number

               in the compile listing .(same as the SEU sequence number
0007.00 - 7th line)

           

              But this gave me an error -

                          "Tried to refer to all or part of an object
that no longer exists."

              Does this mean if DBGVIEW is *SOURCE we cannot debug based
on the SEU source statement?

 

 

             Also surprisingly (Contrary to what is in the docs) .the
same error message was shown when I tried 

             To give BREAK TESTCQS/ 000700   on the same program after I
compiled it with DBGVIEW (*STMT) 

             and option (*SRCSTMT)  

 

 

             In short *SRCSTMT does not have any effect on DBGVIEW
(*SOURCE) and. DBGVIEW (*STMT)?

            

             Please correct me if I am wrong

 

Thanks & Regards,

Shijith 

 

 

 

               

         



DISCLAIMER:
This email (including any attachments) is intended for the sole use of the 
intended recipient/s and may contain material that is CONFIDENTIAL AND PRIVATE 
COMPANY INFORMATION. Any review or reliance by others or copying or 
distribution or forwarding of any or all of the contents in this message is 
STRICTLY PROHIBITED. If you are not the intended recipient, please contact the 
sender by email and delete all copies; your cooperation in this regard is 
appreciated.