RE: RPG400-L Digest, Vol 4, Issue 576

Bruce,

I don't want to do that because that will clear the entire array while
the %realloc will increase the dimension of the array while keeping data
that has already been loaded into the array.

Let's say the array has a max of 10 elements.  
But I want 11.  
So I issue the %realloc to increase the array by another 10 so the max
is 20 (I could increase it by 1, but I'd rather allocate a block of
elements at a time rather than reallocate every time I need the array to
grow).  I'd like to initialize the new block but retain the data that
was already loaded.

Kurt Anderson
Application Developer
Highsmith Inc

-----Original Message-----
From: rpg400-l-bounces@xxxxxxxxxxxx
[mailto:rpg400-l-bounces@xxxxxxxxxxxx] On Behalf Of Bruce Guetzkow
Sent: Thursday, May 26, 2005 8:40 AM
To: rpg400-l@xxxxxxxxxxxx
Subject: RE: RPG400-L Digest, Vol 4, Issue 576

Kurt:

<snip>
Is there any way I can automate the initialization through a keyword
instead of using the FOR loop in the subroutine below?
</snip>

I haven't done this with a dynamic array, but can't you just do the
following after the allocation?
C                   Clear                   ItmAry

This would eliminate the FOR-loop processing at least.  I would think
that initializing the array (with or without the FOR-loop) is your best
bet.

--Bruce Guetzkow

--
This is the RPG programming on the AS400 / iSeries (RPG400-L) mailing
list To post a message email: RPG400-L@xxxxxxxxxxxx To subscribe,
unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/rpg400-l
or email: RPG400-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives at
http://archive.midrange.com/rpg400-l.