Re: Cut-and-paste into SEU

[RPower@xxxxxxxxxx]

Use code400 or wdsc for your editor.  Works nicely.

Ron Power
Programmer
Information Services
City Of St. John's, NL
P.O. Box 908
St. John's, NL
A1C 5M2
Tel: 709-576-8132
Email: rpower@xxxxxxxxxx
Website: http://www.stjohns.ca/
___________________________________________________________________________
Success is going from failure to failure without a loss of enthusiasm. - 
Sir Winston Churchill




MWaite@xxxxxxxxxxxx 
Sent by: rpg400-l-bounces@xxxxxxxxxxxx
19/05/2005 07:54 AM
Please respond to
RPG programming on the AS400 / iSeries <rpg400-l@xxxxxxxxxxxx>


To
RPG400-L@xxxxxxxxxxxx
cc

Subject
Cut-and-paste into SEU






Am I the only one that has trouble cutting 100 lines of (say RPG) source 
out of an e-mail and dropping into a source member using SEU?  I can do 20 

lines fine (ie a screenful), but more than that and my primitive 
cut-and-paste fails me.

I've just done what I wanted (ie grabbed the source for Larry's QTEMP 
manipulator), but had to resort to using Client Access (ie IBM iSeries 
Access for Windows) Data Transfer.  I'm sure I've used FTP in the past as 
well.

Any simple way around this.  I don't mind being embarrassed!



Regards


Mike
-- 
This is the RPG programming on the AS400 / iSeries (RPG400-L) mailing list
To post a message email: RPG400-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/rpg400-l
or email: RPG400-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/rpg400-l.