RE: Passing a PARM using STRDBG

["Bob Cozzi" <cozzi@xxxxxxxxx>]

The same way. You use STRDBG, enter your breakpoints, then press F12.
Unlike STRISDB, the STRDBG command does not evoke the program.
So at this point, you call the RPG IV program and pass in the string for the
parameter.

-Bob Cozzi
www.RPGxTools.com
If everything is under control, you are going too slow.
- Mario Andretti


-----Original Message-----
From: rpg400-l-bounces@xxxxxxxxxxxx [mailto:rpg400-l-bounces@xxxxxxxxxxxx]
On Behalf Of Bob O.
Sent: Tuesday, March 22, 2005 10:20 AM
To: rpg400-l@xxxxxxxxxxxx
Subject: Passing a PARM using STRDBG

I need to debug an RPGLE program that accepts a parameter when it is called.

  When using the old STRISDB for RPGIII/400 program, you can pass the parm 
in the call command.  How is this done using the ILE interactive source 
debugger?


-- 
This is the RPG programming on the AS400 / iSeries (RPG400-L) mailing list
To post a message email: RPG400-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/rpg400-l
or email: RPG400-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/rpg400-l.