Re: CHAIN & Operation Extender

["Rex Capio" <rex_capio@xxxxxxxxxxxxxxxxxxxxx>]

should be:   CHAIN(N)

----- Original Message ----- 
From: "Buzz Fenner" <bfenner@xxxxxxxxxxxxxxxx>
To: "RPG Discussion" <RPG400-L@xxxxxxxxxxxx>
Sent: Tuesday, September 16, 2003 4:45 PM
Subject: CHAIN & Operation Extender


> I've tried to code a simple CHAIN operation without a record lock (code
does
> a lock later) and I cannot get the thing to compile.  Here's the code:
>
> Fglmstrl1  uf   e           k disk
>
> Plus any of the following:
>
> C
> C     frmact        chain     glmstrl1(n)
> C                      if           %found
> C
> C     frmact        chain     glmstrl1 (n)
> C                      if           %found
> C
> C     frmact        chain     glmstrl1(N)
> C                      if           %found
> C
> C     frmact        chain     glmstrl1 (N)
> C                      if           %found
>
>
> Every time, the compiler treats it as an invalid array definition.
>
> *RNF7030 30    188 004400  The name or indicator N is not defined.
> *RNF5064 20    188 004400  An array index is specified for name that is
not
> an array.
>
> I'm using CODE/400, but if I go back to SEU, the same thing happens.  I
must
> be rustier than I thought.
>
> Buzz Fenner
> Systems Analyst/Network Administrator
> Phone: 870.930.3374
> Fax: 870.930.3376
> bfenner@xxxxxxxxxxxxxxxx
>
>
> _______________________________________________
> This is the RPG programming on the AS400 / iSeries (RPG400-L) mailing list
> To post a message email: RPG400-L@xxxxxxxxxxxx
> To subscribe, unsubscribe, or change list options,
> visit: http://lists.midrange.com/mailman/listinfo/rpg400-l
> or email: RPG400-L-request@xxxxxxxxxxxx
> Before posting, please take a moment to review the archives
> at http://archive.midrange.com/rpg400-l.
>
>