RE: The target for a numeric operation is too small to holdtheresult

[Mike Haston ** Data <MHaston@xxxxxxx>]

You can also:

monitor;
on-error;
endmon;

-----Original Message-----
From: Mike Silvers [mailto:msilvers@xxxxxxxxxxx]
Sent: Wednesday, February 19, 2003 1:57 PM
To: RPG programming on the AS400 / iSeries
Subject: Re: The target for a numeric operation is too small to
holdtheresult


This error can happen anytime -- it is a data issue (run time exception).  I
believe that there is an "H" spec you can use to stop this from happening.
I don't remember what it is -- I would have to look it up.

Mike



----- Original Message -----
From: "Chris Beck" <CBeck@xxxxxxxxxxxx>
To: <rpg400-l@xxxxxxxxxxxx>
Sent: Wednesday, February 19, 2003 1:37 PM
Subject: The target for a numeric operation is too small to hold theresult


> Does anyone know of a utility that will check your programs to see if this
error could happen?
>
> Thank,
>
> Chris Beck
>
>
> _______________________________________________
> This is the RPG programming on the AS400 / iSeries (RPG400-L) mailing list
> To post a message email: RPG400-L@xxxxxxxxxxxx
> To subscribe, unsubscribe, or change list options,
> visit: http://lists.midrange.com/mailman/listinfo/rpg400-l
> or email: RPG400-L-request@xxxxxxxxxxxx
> Before posting, please take a moment to review the archives
> at http://archive.midrange.com/rpg400-l.
>
>


_______________________________________________
This is the RPG programming on the AS400 / iSeries (RPG400-L) mailing list
To post a message email: RPG400-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/rpg400-l
or email: RPG400-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/rpg400-l.