URGENT! - Program Error

["Wills, Mike N. (TC)" <MNWills@xxxxxxxxxxxxxx>]

We are on V5R1, this subroutine hasn't been changed in the program, but now
it bombs out on us. I ran debug. It first does a subproceedure that reads a
DDM file and then it clears a file via a CL, which both complete
successfully. Then when it opens a local file, it bombs out with the
messages bellow.

Here are the messages in the job log:
Message . . . . :   Pointer not set for location referenced.
Cause . . . . . :   A pointer was used, either directly or as a basing
  pointer, that has not been set to an address.

 Message . . . . :   Internal failure in compiler or subroutine.
 Cause . . . . . :   An internal error was found in the compiler or in a
   run-time subroutine. Recovery  . . . :   Contact your service
   representative.

 Message . . . . :   Application error.  RNX9998 unmonitored by CUGPRCSMON
at
   statement *N, instruction X'0000'.

 Cause . . . . . :   The application ended abnormally because an exception

   occurred and was not handled.  The name of the program to which the

   unhandled exception is sent is CUGPRCSMON CUGPRCSMON
_QRNP_PEP_CUGPRCSMON.
   The program was stopped at the high-level language statement number(s) *N
at
   the time the message was sent.  If more than one statement number is
shown,
   the program is an optimized ILE program.  Optimization does not allow a

   single statement number to be determined.  If *N is shown as a value, it

   means the real value was not available. Recovery  . . . :   See the low

   level messages previously listed to locate the cause of the exception.

   Correct any errors, and then try the request again.



Any ideas would be greatly appreciated...

Mike Wills
IT Corporate Support
Taylor Corporation
mnwills@taylorcorp.com
Phone: (507) 386-3187