RE: Subprocedures: *OMIT vs. *NOPASS

Hi,

*OMIT is targeted for parameters in the middle of the list, while *NOPASS at
the end of the list.  Personally I only use *NOPASS, and put optional
parameters at the end as they're usually less important.  This also makes
calling the procedure more transparent.

Kind regards,
Paul

-----Original Message-----
From: Bartell, Aaron L. (TC) [mailto:ALBartell@taylorcorp.com]
Sent: 13 March, 2002 16:37
To: 'rpg400-l@midrange.com'
Subject: Subprocedures: *OMIT vs. *NOPASS



A co-worker and I are trying to decide which one of these we should use when
passing data to a subprocedure.  Could I get some opinions on when you feel
each should be used?

Thanks,
Aaron Bartell
_______________________________________________
This is the RPG programming on the AS400 / iSeries (RPG400-L) mailing list
To post a message email: RPG400-L@midrange.com
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/cgi-bin/listinfo/rpg400-l
or email: RPG400-L-request@midrange.com
Before posting, please take a moment to review the archives
at http://archive.midrange.com/rpg400-l.