Found it Re: Pointer not set for location .....

Found it
http://archive.midrange.com/midrange-l/200001/msg00450.html





Slava Zharichenko
05/30/2001 02:38 PM


To:   RPG400-L@midrange.com
cc:

Subject:  Pointer not set for location .....  (Document link: Slava
      Zharichenko)

I am calling RPG procedure from a CL. Procedure returns   1A value.

When RPG hits RETURN opcode the following message appears:

Message ID . . . . . . :   MCH3601       Severity . . . . . . . :   40
Message type . . . . . :   Diagnostic
Date sent  . . . . . . :   05/30/01      Time sent  . . . . . . :
14:37:25
Message . . . . :   Pointer not set for location referenced.
Cause . . . . . :   A pointer was used, either directly or as a basing
  pointer, that has not been set to an address.

I have seen somebody had similar problems but i can not find post for some
reason.
Thanks







______________________________________________________________________

Important Email Information



The information in this email is confidential and may be legally
privileged. It is intended solely for the addressee. Access to this email
by anyone else is unauthorized. If you are not the intended recipient, any
disclosure, copying, distribution or any action taken or omitted to be
taken in reliance on it, is prohibited and may be unlawful. If you are not
the intended addressee please contact the sender and dispose of this
e-mail.


+---
| This is the RPG/400 Mailing List!
| To submit a new message, send your mail to RPG400-L@midrange.com.
| To subscribe to this list send email to RPG400-L-SUB@midrange.com.
| To unsubscribe from this list send email to RPG400-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---