RE: ACQ - ICFW status during acquire on ICF file

[Billy Rowe <billyrowe@xxxxxxx>]

I have a program that is trying to acquire an ICF file in order to 
     submit a credit report request. The program stops at the ACQ statement 
     and the job goes into ICFW status. The job log shows that
     the device name I am using was added to the ICF file and the remote
     location I am using to chain to the ICF file is correct.
     
     The acquire statements appears as shown below


 *
     FICF     CF  E                    WORKSTN      KNUM        1
     F                                              KINFDS FEEDBK
     F                                              KINFSR EXCPTH

I* Program information data structure
     IFEEDBK      DS
     I                                       38  45 FMTNAM
     I                                      273 282 PGMDEV
     I                                      401 404 MAJMIN
     I                                      401 402 MAJCOD
     I                                      403 404 MINCOD
     CL0N01Factor1+++++++Opcode&ExtFactor2+++++++Result++++++++Len++D+HiLoE
     Q 
     0112.00 C     CCRMTLOC      Acq       CBU000F                      99  
             C     MAJMIN    CABGT'0000'    ERROR            *** ERROR

The next statement after your 'ACQ', Check the Major/Minor return codes
via the feddback area, if they are are greater than 0 then look up the
error in the ICF programmers reference.


If the Major/Minor codes are 0, then either issue a program evoke on the
remote system, or do a read to your ICF format to receive data from the
program that evoked your program.

It's been a few years since I did any APPC ICF programming,
but I hope this Helps.

Billy



____________________________________________________________________
Get free email and a permanent address at http://www.amexmail.com/?A=1
+---
| This is the RPG/400 Mailing List!
| To submit a new message, send your mail to RPG400-L@midrange.com.
| To subscribe to this list send email to RPG400-L-SUB@midrange.com.
| To unsubscribe from this list send email to RPG400-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---