RE: System 36 RPG Division by zero

["Peter L. Hotchkiss" <sir.zetar@xxxxxxxxxxxxxxx>]

Nope.  Both the S/34 & S/36 RPG II always threw a division by zero error.  I
believe the only options were 2 & 3.  (2 was end job step, but continue OCL
procedure; 3 was end job step and OCL procedure.)

-Pete

-----Original Message-----
From: owner-rpg400-l@midrange.com [mailto:owner-rpg400-l@midrange.com]On
Behalf Of John Hall
Sent: Friday, March 16, 2001 9:07 AM
To: RPG400-L@midrange.com
Subject: System 36 RPG Division by zero


I have program that was converted from RPGII to RPG IV.

It is coming up with a division by zero error.  As far as I can tell
this program (last run a few years ago) would always have a division by
zero in it.

Can anyone tell me what the behavior would be running as an RPGII
program - i.e. would it just stick a zero in the result field and keep
going.

John Hall
Home Sales Co.
+---
| This is the RPG/400 Mailing List!
| To submit a new message, send your mail to RPG400-L@midrange.com.
| To subscribe to this list send email to RPG400-L-SUB@midrange.com.
| To unsubscribe from this list send email to RPG400-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator:
david@midrange.com
+---

+---
| This is the RPG/400 Mailing List!
| To submit a new message, send your mail to RPG400-L@midrange.com.
| To subscribe to this list send email to RPG400-L-SUB@midrange.com.
| To unsubscribe from this list send email to RPG400-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---