RE: Sockets in RPGLE

[Chris Bipes <ChrisB@xxxxxxxxxxxxxxx>]

Thank You for all your help.  Now I have two ways of coding the same
prototype.  The following also works:
 *------------------------------------------------------------------ 
 * Prototype for InetAddr().                                         
 *------------------------------------------------------------------ 
D InetAddr        PR            10i 0 ExtProc('inet_addr')           
D SocketId                      15A                                  
 *------------------------------------------------------------------ 
Notice the exclusion of the "VALUE" parameter.  This tip was from Bruce at
IBM.  I did not under stand what the "VALUE" parameter was until now.

C                   EVAL      sin_addr = inetaddr(TcpAddr)

Either way you get correct results.


Christopher K. Bipes            mailto:ChrisB@Cross-Check.com
Sr. Programmer/Analyst          mailto:Chris_Bipes@Yahoo.com
CrossCheck, Inc.                http:\\www.cross-check.com
6119 State Farm Drive           Phone: 707 586-0551 x 1102
Rohnert Park  CA  94928         Fax: 707 586-1884

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* This is the RPG/400 Discussion Mailing List!  To submit a new         *
* message, send your mail to "RPG400-L@midrange.com".  To unsubscribe   *
* from this list send email to MAJORDOMO@midrange.com and specify       *
* 'unsubscribe RPG400-L' in the body of your message.  Questions should *
* be directed to the list owner / operator: david@midrange.com          *
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *