Does anything show up if you issue:
WRKJOBLOG PERIOD((*AVAIL *BEGIN))
On Thursday, February 16, 2023 at 01:57:48 PM EST, Rich Loeber <rich@xxxxxxxxx> wrote:
Nope, it is set like this:
Job log output . . . . : *JOBEND
On 2/16/2023 1:50 PM, Mark Waterbury wrote:
What is the system value QLOGOUTPUT set to?
(I am going to guess it is sent to "*PND" ...)
On Thursday, February 16, 2023 at 01:39:40 PM EST, Rich Loeber <rich@xxxxxxxxx><mailto:rich@xxxxxxxxx> wrote:
That just tells me to check job queues (done) output queues (done) and active jobs (done). I see about 30 jobs in output queues, no jobs in job queues and a few hundred jobs active. Is there another category of active jobs that I'm missing.
Even stranger, I IPLd the system and the high number persists following the IPL.
On 2/16/2023 1:33 PM, Mark Waterbury wrote:
In that WRKSYSSTS display screen, put the cursor right on top of that number of jobs (11918) and press F1=Help. It will tell you what those are all about ...
Mark S. Waterbury
On Thursday, February 16, 2023 at 01:29:54 PM EST, Rich Loeber <rich@xxxxxxxxx><mailto:rich@xxxxxxxxx><mailto:rich@xxxxxxxxx><mailto:rich@xxxxxxxxx> wrote:
I'm running a test partition on a system and there are only 2 or 3 users. When I run WRKSYSSTS, I sometimes see an unusually high number of jobs in the system. Right now it is showing 11918. I see no more than a few hundred jobs running in WRKACTJOB, there are a few spool files in some output queues and no jobs in any job queues. So .... where are all those jobs?
Kisco Systems LLC
As an Amazon Associate we earn from qualifying purchases.