Re: How to reboot a virtual I/O?

["Larry \"DrFranken\" Bolhuis" <midrange@xxxxxxxxxxxx>]

Curiously if the IOP is for an iSCSI Virtual Tape you CAN IPL the IOP 
from SQL.

So your idea is a good one!

	- DrF

On 6/29/2022 1:57 PM, Bryan Dietz wrote:
> Larry, i put in a "idea" to allow for the re-ipl of the VTL IOA to be 
> done at the command line.
> we've had to do the same for Protect Tier and data domain.
>
>
> cannot figure out the new interface to find a direct link, but search 
> for:  IBMI-I-1048 https://ideas.ibm.com/
>
>
> --
> Bryan
>
>
>
>
>
> Larry "DrFranken" Bolhuis wrote on 6/29/2022 12:16 PM:
> > Same really, just go into SST and under concurrent maintenance restart 
> > the virtual IOP. We do this routinely to get Cybernetics VTLs talking 
> > to the system again.
> >
> >      - DrF
> >
> > On 6/29/2022 1:00 PM, Rob Berendt wrote:
> > > Back when we had a physical card, like a scsi tape card for example, 
> > > and we just wanted to reboot a card I knew how to go into SST and 
> > > reboot that card.
> > > Now let's say we have a FC card that's dedicated to a lpar of VIOS 
> > > and that is hosted to a few lpars of IBM i.  This FC is just for tape 
> > > and not disk.
> > > Is there a way to reboot that card without rebooting vios and then 
> > > all lpars of IBM i?
> > >
> > > Rob Berendt
> > > --
> > > IBM Certified System Administrator - IBM i 6.1
> > > Group Dekko
> > > Dept 1600
> > > Mail to:  7310 Innovation Blvd, Suite 104
> > >            Ft. Wayne, IN 46818
> > > Ship to:  7310 Innovation Blvd, Dock 9C
> > >            Ft. Wayne, IN 46818
> > > http://www.dekko.com