Re: [WEB400] IWS, REST APIs, and Logging

New logging enhancments! See https://www.ibm.com/support/pages/node/633935


________________________________



At this time logging payloads is not supported. Although there are plans
on implementing this.

You can do a trick where you have input parameter that is of character
type and not injected from any input source, with a length large enough to
handle input request, and best to make it varchar.

Then any REST requests that are inbound will be put into the parameter
as-is. It will not be parsed. Thus, it is up to you to do the parsing.


"WEB400" <web400-bounces@xxxxxxxxxxxxxxxxxx> wrote on 04/27/2021 10:23:55
AM:

From: Stephen Piland <Stephen@xxxxxxxxxxxxxxxxxxxxxxxxxxxxx>
To: "web400@xxxxxxxxxxxxxxxxxx" <web400@xxxxxxxxxxxxxxxxxx>
Date: 04/27/2021 10:24 AM
Subject: [EXTERNAL] [WEB400] IWS, REST APIs, and Logging
Sent by: "WEB400" <web400-bounces@xxxxxxxxxxxxxxxxxx>

I haven't seen any way to do this so far, but I thought I'd ask the

group...

Is there any way to capture the 'payload'/body sent in? Ideally,
pre-execution of the program or service program call from within
IWS. If not, is there a way to capture it in the called pgm perhaps
as a BLOB that could be stored?

Thanks!
--