Re: Mult MONMSG not working as expected

It is a typo on the CPFA09E, but below that you are saying exactly what I said. I did go look through some of our save logs, and CPFA09E and CPD384E are both diagnostic messages in our saves.

So the CPA09E was ignored

by the first monmsg because you don't have an EXEC. The second one then

checks it, and it qualifies, so it executes your code.

This is not correct.

It might be because Kevin mistyped CPA09E and didn't realize the ID was CPFA09E and is listed in both the MONMSG block and the info from the joblog.



<snip>


A MONMSG without the EXEC section will "IGNORE" that escape message if the CL program receives it.

The program will then continue to the next command in the CL Program.

</snip>



[https://www.medtronsoftware.com/img/MedtronMinilogo.bmp] Kevin Bucknum
Senior Programmer Analyst
MEDDATA / MEDTRON
120 Innwood Drive
Covington LA 70433
Local: 985-893-2550
Toll Free: 877-893-2550
https://www.medtronsoftware.com



CONFIDENTIALITY NOTICE

This document and any accompanying this email transmission contain confidential information, belonging to the sender that is legally privileged. This information is intended only for the use of the individual or entity named above. The authorized recipient of this information is prohibited from disclosing this information to any other party and is required to destroy the information after its stated need has been fulfilled. If you are not the intended recipient, or the employee of agent responsible to deliver it to the intended recipient, you are hereby notified that any disclosure, copying, distribution or action taken in reliance on the contents of these documents is STRICTLY PROHIBITED. If you have received this email in error, please notify the sender immediately to arrange for return or destruction of these documents.