Re: Power9 with Direct Attached V50x0

[DrFranken <midrange@xxxxxxxxxxxx>]

This would be my first question as well. You certainly need the host 
controller with at least one disk of 39554383872 Bytes or larger 
attached for the load source disk. That number creates a 35GB disk, the 
minimum for i 7.2 and up.

        - Larry "DrFranken" Bolhuis

www.Frankeni.com
www.iDevCloud.com - Personal Development IBM i timeshare service.
www.iInTheCloud.com - Commercial IBM i Cloud Hosting.

On 7/29/2019 9:48 AM, Steve Pavlichek wrote:
> Have you created the HOST connections on the v5010?  The v5010 Volumes need to mapped to the WWPNs of the fiber adapters on the POWER9.
>
> Direct connect is supported with 16GB on both ends.
>
> From: Diego Kesselman<mailto:diegokesselman@xxxxxxxxx>
> Sent: Monday, July 29, 2019 9:39 AM
> To: Midrange Systems Technical Discussion<mailto:midrange-l@xxxxxxxxxxxxxxxxxx>
> Subject: Power9 with Direct Attached V50x0
>
> Hi all,
>
> I'm trying to connect a new Power9 (41A) with EN0A (16Gb FC adapter) to
> a V5010E with 16Gb controllers.We have V7R3.
> According to SSIC , this is possible on Power8, and according to some
> PDFs this is possible with 16Gb-16Gb adapter-controller connection on
> Storwize and SVC systems.
>
> The issue is... we can't see any disk when trying to install LIC. We
> have tried with 80GB, 100GB and 200GB disks with no luck.
>
> Any clue ? Is it possible to connect this way (without VIOS)? Do I have
> to perform any special task? On Diret SAN Attachment I've seen this is
> transparent.
>
> Regards
>
> Diego E. Kesselman
>
>
> --