Does anything here help you?
http://www-01.ibm.com/support/docview.wss?uid=nas8N1017618
George
(712) 579-5444 (cell)
985 Oak Rd
Harlan, IA 51537
-----Original Message-----
From: MIDRANGE-L [mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Danny
Hayes
Sent: Thursday, February 15, 2018 1:50 PM
To: MIDRANGE-L@xxxxxxxxxxxx
Subject: Using IACS .dtfx from a CL program
Has anyone been successful at using ACS data transfer from inside a cl
program.
I remember this used to be quite simple, way back when.
I have had zero luck with RTOPCB, RXFERPCB , SBMJOB CMD(QSH and SBMJOB
CMD(RUNJVA.
I know these are not new, but I have not had a reason to try for a few
years.
Any guidance and heckling will be cheerfully accpeted.
Thanks & Regards,
Danny Hayes
IT-Developer
Genuine Parts Company, APG IT
[APGIT_EmailHeader]
3100 Windy Hill Road
Atlanta, Georgia 30339
mailto:Danny_Hayes@xxxxxxxxx
Why is it that all of the instruments seeking intelligent life in the
universe are pointed away from earth?
"This e-mail and any attachments, contain Genuine Parts Company confidential
information that is proprietary, privileged, and protected by applicable
laws. If you have received this message in error and are not the intended
recipient, you should not retain, distribute, disclose or use any of this
information and you should destroy this e-mail, any attachments or copies
therein forthwith. Please notify the sender immediately by e-mail if you
have received this e-mail in error."
As an Amazon Associate we earn from qualifying purchases.