Re: What's the proper way to "reraise" in a CLP?

On Mon, Jun 19, 2017 at 9:46 AM, Buck Calabro <kc2hiz@xxxxxxxxx> wrote:

On 6/16/2017 7:37 PM, John Yeung wrote:

So, nobody mentioned it explicitly, probably because it's too obvious
to everyone who knows what they are doing, but after further
experimentation it seems that the key to this is to specify
TOPGMQ(*SAME) when issuing the SNDPGMMSG that repeats the originally
caught *ESCAPE message.

Generally, I would send to *PRV; that is, to the caller.

That is the default, and I tried that as well as a few other
combinations. None of them do what I wanted, except for TOPGMQ(*SAME).
I hope it is clear that my paragraph quoted above is all about how I
established, *through experimentation* that TOPGMQ(*SAME) works for
me. It does what I wanted, at least on my system.

Sending it to
the program that just handled the message would result in a loop unless
there was code to detect that we've seen this one before.

Are you talking about global MONMSG? I'm only using MONMSG immediately
following a command that I know may fail. I'm not getting any looping
behavior.

John Y.