AW: Values into Issue

Just add a Dynamik were condition After the from clause. It is even possible to use Parameter Marktes with in this were clauseBirgitta 


Von meinem Samsung Gerät gesendet.

-------- Ursprüngliche Nachricht --------
Von: broehmer@xxxxxxxxxxxxxxx
Datum: 16.07.2016 01:11 (GMT+01:00)
An: Midrange Systems Technical Discussion <midrange-l@xxxxxxxxxxxx>
Betreff: Values into Issue

Can someone point out where the "where"  can/should go
in the following imbeded SQL statement:?

strsql = 'Values (Select Count(*) ' +
                    'From ' + %trim(filein) + ') into ?';
           exec sql prepare DynSql from :strsql;
           exec sql Execute DynSql using :Countc;

I want to limit the selection and need to select certain records.  The
above works fine assuming
I want to count them all.

TIA


Bill

"CONFIDENTIALITY NOTICE:  This e-mail transmission (and/or the attachments accompanying it) contain confidential information belonging to the sender.  The information is intended only for the use of the intended recipient.  If you are not the intended recipient, you are hereby notified that any disclosure, copying, distribution or the taking of any action in reliance on the contents of the information is strictly prohibited.  Any unauthorized interception of this transmission is illegal under the law.  If you have received this transmission in error, please promptly notify the sender by reply e-mail, and then destroy all copies of the transmission."