Re: Failed GO SAVE 21

[W3 <welly.soegiantoro@xxxxxxxxx>]

Hi John,
Looking @ the message it is said that the tap35 not valid... What I usually
do is when this thing happen is I call IBM to replace the drive.. The drive
could be at the end of their time :-D

Br,
Welly
On Aug 26, 2015 10:34 PM, "John McKee" <jmmckee3@xxxxxxxxx> wrote:

> It happened again.  Runs along fine, then aborts.
>
> I did get a job log.
>
> System also created QPSRVDMP.
>
> The 3590 device is in FAILED state.
>
> From looking at QEZDEBUG, I see from the call stack, the last three entries
> are:
>
> qsrProcessIoReqForGroup_FP7qsrList
> qsrSwitchMediaVolume_FP15qsrIO_Request_T13qsrTypeOfFEOV
> qsrFeovDevUfcb_FP9qsrFileCb
>
> From looking at QSYSOPR, there is CPI5922 Device description TAP35 is not
> usable at this time.  No other error message related to the drive before or
> after that message.
>
> From QPSRVDMP
>
> DUMP TAKEN FOR UNMONITORED ESCAPE MESSAGE
>
> MCH5203 Condition of source/sink object TAP35 not valid.
>
> System (v5r4) has 246.1G and %system ASP used is 67.4779
>
> My WAG is that the tape got full.  But, unlike last week, I never saw a
> message requesting a tape change.  Last week, I did see that message along
> with a message that tape drive needed to be cleaned - which I did last
> week.
>
> So, any idea as to why there was no tape change message?
>
> John McKee
> --
> This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
> To post a message email: MIDRANGE-L@xxxxxxxxxxxx
> To subscribe, unsubscribe, or change list options,
> visit: http://lists.midrange.com/mailman/listinfo/midrange-l
> or email: MIDRANGE-L-request@xxxxxxxxxxxx
> Before posting, please take a moment to review the archives
> at http://archive.midrange.com/midrange-l.