It happened again. Runs along fine, then aborts.

I did get a job log.

System also created QPSRVDMP.

The 3590 device is in FAILED state.

From looking at QEZDEBUG, I see from the call stack, the last three entries
are:

qsrProcessIoReqForGroup_FP7qsrList
qsrSwitchMediaVolume_FP15qsrIO_Request_T13qsrTypeOfFEOV
qsrFeovDevUfcb_FP9qsrFileCb

From looking at QSYSOPR, there is CPI5922 Device description TAP35 is not
usable at this time. No other error message related to the drive before or
after that message.

From QPSRVDMP

DUMP TAKEN FOR UNMONITORED ESCAPE MESSAGE

MCH5203 Condition of source/sink object TAP35 not valid.

System (v5r4) has 246.1G and %system ASP used is 67.4779

My WAG is that the tape got full. But, unlike last week, I never saw a
message requesting a tape change. Last week, I did see that message along
with a message that tape drive needed to be cleaned - which I did last week.

So, any idea as to why there was no tape change message?

John McKee

This thread ...

Follow-Ups:

Follow On AppleNews
Return to Archive home page | Return to MIDRANGE.COM home page

This mailing list archive is Copyright 1997-2019 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].