Creating a printer device for Toshiba e-studio 950

I've looked at the printer help web pages and the CRTDEVPRT command information at Knowledge Center but there's no help that I can find that helps me know what parameter values to use for the command for this printer.

The printer is a Toshiba e-studio 950. I already have it set up in the TCP/IP host table entries.

I need to find the values for parameters TYPE() and MODEL(), with DEVCLS(*VRT).

Is ASCII enough?

Thanks
Alan

--------------------------------------------------------------------------------
Confidentiality Notice: This email may contain confidential information or information covered under the Privacy Act, 5 USC 552(a), and/or the Health Insurance Portability and Accountability Act (PL 104-191) and its various implementing regulations and must be protected in accordance with those provisions. It contains information that is legally privileged, confidential or otherwise protected from use or disclosure. This e-mail message, including any attachments, is for the sole use of the intended recipient(s). Any unauthorized review, use, disclosure or distribution is prohibited. You, the recipient, are obligated to maintain it in a safe, secure and confidential manner. If you are not the intended recipient, please contact the sender by reply e-mail and destroy all copies of the original message. Thank you.
--------------------------------------------------------------------------------