RE: RCVF in CL

Date: Mon, 9 Feb 2015 15:35:12 -0600
Subject: Re: RCVF in CL
From: bvining@xxxxxxxxxxxxxxx
To: midrange-l@xxxxxxxxxxxx

If you're on a reasonably current release, check out the CLOSE CL command.
You close the file and the next RCVF reopens it at the start.

Bruce Vining

On Mon, Feb 9, 2015 at 3:26 PM, Rich Loeber <rich@xxxxxxxxx> wrote:

Thanks .... I'm seeing about this now. Looks like it should work.

Rich


--------------------------------------------------------------------------

On 2/9/2015 4:18 PM, Booth Martin wrote:

Is this what you are looking for?

POSDBF OPNID(XXX) POSITION(*START)

On 2/9/2015 3:09 PM, Rich Loeber wrote:

I have a program that reads a short source physical file during
processing. Over the course of processing, it may need to go
back
and
re-read the file again and I've hit a brain cramp on how to get
it
to
start over without ending the program.

Is there a secret here?

Rich
--
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/midrange-l.

--
Regards,
Bruce
www.brucevining.com
www.powercl.com
--
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/midrange-l.