× The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.



Sounds like the IOP reset was the key.

--
Jim Oberholtzer
Chief Technical Architect
Agile Technology Architects

-----Original Message-----
From: MIDRANGE-L [mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Bob
Cagle
Sent: Monday, February 02, 2015 8:06 AM
To: Midrange Systems Technical Discussion
Subject: RE: LTO backup drive failing?

I performed an IPL over the weekend and the drive is functioning normally
again. Hopefully it stays that way.

Thanks for everyone's input.

Bob Cagle
IT Manager
Lynk, Inc.

-----Original Message-----
From: MIDRANGE-L [mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of
Steinmetz, Paul
Sent: Sunday, February 1, 2015 1:22 PM
To: 'Midrange Systems Technical Discussion'
Subject: RE: LTO backup drive failing?

Bob,

1) What is the status of below command? (should show varied on).

WRKCFGSTS CFGTYPE(*DEV) CFGD(TAP02)

2) If varied on, below is a quick test if the drive is at least
communicating successfully.

DSPTAP DEV(TAP02) VOL(*MOUNTED) DATA(*SAVRST)

Paul



-----Original Message-----
From: MIDRANGE-L [mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Bob
Cagle
Sent: Saturday, January 31, 2015 12:27 PM
To: Midrange Systems Technical Discussion
Subject: RE: LTO backup drive failing?

1) PTFs current: No - on 7.1, but a bit behind on PTFs. Current level is
12279. Yes, I need to update. Was holding out hope for new 7.2 machine.

2) Did you try a different tape?: Yes

3) Vary off/on IOP reset *yes: Performed an IPL instead (again: very, very
small shop) Will see if it had any effect come next backup (Monday morning)

4) Which LTO 3,4 or 5?: Not sure; does it really matter?

5) Fiber, SCSI, SAS?: SCSI

6) Tape firmware current?: Probably not; haven't updated it since I got it.
Not sure how to even do that yet.

-----Original Message-----
From: MIDRANGE-L [mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of
Steinmetz, Paul
Sent: Friday, January 30, 2015 3:50 PM
To: 'MIDRANGE-L@xxxxxxxxxxxx'
Subject: RE: LTO backup drive failing?

1) PTFs current
2) Did you try a different tape?
3) Vary off/on IOP reset *yes, make sure no disks on same IOP
4) Which LTO 3,4 or 5?
5) Fiber, SCSI, SAS?
6) Tape firmware current?

Paul

-----Original Message-----
From: MIDRANGE-L [mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Bob
Cagle
Sent: Friday, January 30, 2015 12:04 PM
To: MIDRANGE-L@xxxxxxxxxxxx
Subject: LTO backup drive failing?

I have an external IBM Ultrium LTO drive - 3580-003, attached to an i5 520
that I *think* might be failing. The last three mornings the backup job has
been stuck in an EVTW status with the drive's activity light blinking. The
job log shows that only the first library has been saved. My guess is that
it's attempting to write the library to tape, but the tape is just spinning.
The only thing I can think that I did different is that I actually cleaned
it with a cleaning cartridge the day before this began. Yes, I've cleaned
it before, with the same cartridge, about 6 months ago...

The backup job is just a CL that begins with SAVLIB *ALLUSR, then does a
SAVDLO, SAVSECDTA, SAVCFG, and SAV. The backup normally takes around 3
hours to finish completely, but it is getting stuck on this first library
for over 5 hours. (We're a really, really small shop)

There are no obvious errors that I can find. After some digging, I found
the Service Action Log in the Hardware Service Manager of SST, and two NEW
entries are shown here for both resource DC03 and TAP02 (which is the
problem drive). So I guess that is proof that *something* is wrong.

My next step is to place a service request with IBM, but thought I would
post here to see if anyone had any ideas what might be wrong. The tape
drive was purchased used almost two years ago.

Thanks for any input.

Bob Cagle
IT Manager
Lynk, Inc.

--
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx To subscribe, unsubscribe,
or change list options,
visit: http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx Before posting, please take a
moment to review the archives at http://archive.midrange.com/midrange-l.



As an Amazon Associate we earn from qualifying purchases.

This thread ...

Replies:

Follow On AppleNews
Return to Archive home page | Return to MIDRANGE.COM home page

This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].

Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.