Re: Remote 520 print to local 520

John,
Did you start the Remote Writer on the remote system?
Start Remote Writer (STRRMTWTR)
The Start Remote Writer (STRRMTWTR) command starts a spooling write
that sends spooled files from an output queue to a remote system.
The writer, which is a system job, takes spooled files from an
output queue and sends them to a remote system using SNADS or
TCP/IP.

Jeff Young
Sr. Programmer Analyst

On Wed, Dec 17, 2014 at 10:29 PM, John McKee <jmmckee@xxxxxxxxxxxxxx> wrote:

I didn't spend a lot of time on this. Not sure how badly I might need it.
But, it did not work. Maybe the LPD service was not started. Forget how
to check for it. Maybe firewalls between the systems are the issue.

On remote system, I created an output queue. Used internet address of
local 520. Used library/outq of a known queue. On remote system, created
a spool file and changed output queue to the newly created outq. File went
to SND. Never saw any messages on either system.

Since connection was not *SNA, I chose OTHER instead of AS/400 per help on
remote v5r3 system.

Is there any way to know where it got blocked?

John McKee
--
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/midrange-l.