RE: best method to monitor QSYSOPR queue

["Vincent Forbes" <vforbes@xxxxxxxxx>]

Do not forget to check the QSYSMSG msgq, if you have it.


On 10/08/14, Justin Taylor  <JUSTIN@xxxxxxxxxxxxx> wrote:
> We have a job that reads the QSYSOPR msgq every 5 minutes using the QGYOLMSG API, checking for inquiry messages and critical messages.
>
>
>
> -----Original Message-----
> From: Jim Franz [mailto:franz9000@xxxxxxxxx] <franz9000@xxxxxxxxx]> 
> Sent: Wednesday, October 08, 2014 9:04 AM
> To: Midrange Systems Technical Discussion
> Subject: best method to monitor QSYSOPR queue
>
> Have been tasked to implement a monitor over QSYSOPR message queue for messages with halts, plus hardware warnings, on V7R1 system. No $$, and little time. Needs to send email to multiple addresses (in a table). Lot's of network staff & programmers, but no one watches the i (till something goes missing..) In pre-navigator or Systems Director days it was not too hard to do. Sys Director not currently implemented, and appears to take some time to set up.
> What are people doing these days (when no budget for software, and only a few hrs allocated as a side project)?
> Jim Franz
>
> -- 
> This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
> To post a message email: MIDRANGE-L@xxxxxxxxxxxx
> To subscribe, unsubscribe, or change list options,
> visit: http://lists.midrange.com/mailman/listinfo/midrange-l
> or email: MIDRANGE-L-request@xxxxxxxxxxxx
> Before posting, please take a moment to review the archives
> at http://archive.midrange.com/midrange-l.