RE: Configuring HPRIP controllers

Make sure your WRKCFGL are correct on both LPARS.

If you previously used ANYNET you may/will have to change Remote Control Point from ANYNET to the remote system name.
Remote Remote Control Local Pre-
Remote Network Local Control Point Secure Single Number of Control established
Location ID Location Point Net ID Loc Session Conversations Point Session
PENCOR04 APPN PENCOR09 ANYNET APPN *YES *NO 10 *NO *NO
PENCOR05 APPN PENCOR06 PENCOR05 APPN *YES *NO 10 *NO *NO
PENCOR07 APPN PENCOR06 PENCOR07 APPN *YES *NO 10 *NO *NO
PENCOR08 APPN PENCOR06 PENCOR08 APPN *YES *NO 10 *NO *NO

Paul

-----Original Message-----
From: MIDRANGE-L [mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of kevin
Sent: Thursday, August 07, 2014 11:55 AM
To: midrange-l@xxxxxxxxxxxx
Subject: Re: Configuring HPRIP controllers

This is odd..

I can Telnet to the 7.1 system in question from my pc using client access..I can ping the 7.1 system from my PC..

I cannot ping the 7.1 system from my 5.4 box - I can ping their old 4.4 box from my 5.4 system and of course I have connectivity to both boxes via client access.

I used to use AnyNet to the old 4.4 box - but wanted to upgrade.

I can only assume the vary on is not working because I cannot ping the box from my 5.4 box..

Any thoughts..??

Thanks

Kevin
--
*Kevin Passey*
*KDP Software Limited*
*http://www.kdpsoftware.co.uk*
*Tel:08450 604123*
*Linkedin: https://www.linkedin.com/pub/kevin-passey/12/807/890*
*Twitter: http://www.twitter.com/kpassey*
--
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list To post a message email: MIDRANGE-L@xxxxxxxxxxxx To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx Before posting, please take a moment to review the archives at http://archive.midrange.com/midrange-l.