On 15-Jan-2014 11:22 -0800, Steinmetz, Paul wrote:
<<SNIP>>

I'm not quite clear on the profiles. They have 3. If you display
them, minor differences on the one screen.

Installation Profile : QIBMRPLRLS

Enable automatic
configuration . . : *SAME

Device configuration
naming . . . . . . : *SAME

Default special
environment . . . : *SAME

Installation Profile : QINSNEWSYS

Enable automatic
configuration . . : Y

Device configuration
naming . . . . . . : *NORMAL

Default special
environment . . . : *NONE


The "Install New System" profile establishes a non-S/36EE [native] configuration, whereas the "Install Replace Release" leaves unchanged, whatever was previously established on the system; i.e. the prior configuration, with regard to the system values QAUTCFG, QDEVNAMING, and QSPCENV, remain the _same_ as they were. If that RplRls installation profile is used for a new installation, then those system values will be set to the defaults [the "shipped value"], which happen to match what are shown in the above NewSys installation profile.


This thread ...

Follow-Ups:
Replies:

Follow On AppleNews
Return to Archive home page | Return to MIDRANGE.COM home page

This mailing list archive is Copyright 1997-2019 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].