|
Booth -
Configuration is required for the VPN client on your PC, usually by the
system administration group or they give you the host name/ip address
information and instructions on how to configure it yourself.
After the client is properly configured, you must login to the VPN client on
your PC and start a session with the host system. Once the VPN connection
is established, it is like your PC is on their local network and you can
then open the IBM i applications and get connected to the IBM systems.
"Booth Martin" wrote in message
news:mailman.2415.1386995257.2717.midrange-l@xxxxxxxxxxxx...
I suspect I am about to look like an idiot again. No big deal. I am
used to it.
Is there a tutorial or instructions on how to connect with VPN?
I have Client Access, iSeries Navigator, and RDi. I have used VPN with
Client access but that setup was in 2009 and I have no idea how I did it
back then,
The VPN I am trying to use to connect is: SHREW SOFT VPN CLIENT That
installed, and it shows as connected when I start it. But I can't
figure out what to do next.
As an Amazon Associate we earn from qualifying purchases.
This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].
Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.
midrange.com
