×
The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.
Yes, a CR3 can handle Power 7. As per:
http://www-933.ibm.com/support/fixcentral/firmware/readme?fixid=MH01343
We're running a couple of CR2's which will not.
"HMC V7R760 was the last release supported on models 7310-C04 and
7310-CR2." Which leads me to believe that 7.7.7 should work on your CR3.
Check
https://www14.software.ibm.com/webapp/set2/sas/f/power5cm/supportedcode.html
and
DSPFMWSTS
to ensure that you're ready to rock.
As soon as you get to HMC change your system to upgrade firmware from that
and NOT *OPSYS! Otherwise there is a potential to upgrade your firmware
past that which your HMC will support.
I will say that we went from HMC V5 to V7 after I saw the capabilities of
V7. Awesome compared to earlier releases. We had to step upgrade
hmc-firmware-hmc-firmware-hmc-... to get there. We were really behind.
(see previous paragraph)
STW on Infocenter and changing console.
One link (that started acting up while I was using it)
http://publib.boulder.ibm.com/infocenter/systems/scope/hw/index.jsp?topic=/iphca/chgconsoles.htm
http://pic.dhe.ibm.com/infocenter/iseries/v7r1m0/topic/rzahc/rzahcswsdsppor2t.htm
Rob Berendt
This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact
[javascript protected email address].
Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.
midrange.com
