Scott - I've tried IP addresses within the domain and they work, but outside the domain they don't.
Rob:
Our domain name is local.customcall.com.
I'm told our domain controller is dc1.customcall.com, and the other dc is MSN-DC-001.edge.local.com.
Currently our Domain Search list is *DFT - which according to the help means it uses the domain name.
So I'm not sure if I should change the domain search to use the customcall.com's local or dc1 address.
I don't want to break anything...
-Kurt
-----Original Message-----
From: midrange-l-bounces@xxxxxxxxxxxx [mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of rob@xxxxxxxxx
Sent: Monday, May 13, 2013 10:40 AM
To: Midrange Systems Technical Discussion
Subject: Re: QNTC and multiple Domain Controllers
CFGTCP
12. Change TCP/IP domain information
Page Down
Domain search list . . . . . . . 'dekko-1 corp.dekko.com dekko.com'
space between each domain.
Rob Berendt
--
IBM Certified System Administrator - IBM i 6.1 Group Dekko Dept 1600 Mail to: 2505 Dekko Drive
Garrett, IN 46738
Ship to: Dock 108
6928N 400E
Kendallville, IN 46755
http://www.dekko.com
From: "Anderson, Kurt" <KAnderson@xxxxxxxxxxxx>
To: "'Midrange Systems Technical Discussion'"
<midrange-l@xxxxxxxxxxxx>,
Date: 05/13/2013 10:04 AM
Subject: QNTC and multiple Domain Controllers
Sent by: midrange-l-bounces@xxxxxxxxxxxx
Am I right in thinking that when using QNTC (which I believe uses
NetServer) it can only connect to one domain controller?
After our company was bought out, we've had a partial transition to the
owner's domain controller. The rest of the transition will occur
eventually, but we're not there yet. Our Power system is on the old
domain, but I am looking to access a new server on the new domain. I
asked that the new server be temporarily added to the old domain until our
Power system was moved to the new domain, but corporate isn't excited
about that (and I honestly don't blame them).
So - if getting QNTC to recognize multiple domain controllers is a
possibility, I'd like to get that set up, otherwise I'll just have to push
on getting our Power system on the new domain.
Sidenote: I am not networking minded, so please keep it simple. ;)
IBM i 7.1
I was using this as a reference. In #8.c it says all servers must be on
the same domain, but I'm thinking that's just for the DNS config option?
http://www-01.ibm.com/support/docview.wss?uid=nas1aea450153eebf8ff8625670f0072550f
Kurt Anderson
Sr Programmer/Analyst
CustomCall Data Systems, a division of Enghouse Interactive Ltd.
midrange.com
